Postable 3d Flower Tutorial

Hi there,

I love it when you make projects using my tutorials but please be sure to link back here and give credit when you make and post to your blog.

Thank-you for your understanding and I hope you enjoy this tutorial xx

So, I am finally getting to show you this postable 3d flower. I say postable, it will be a large letter here in the U.K. but smaller than my other 3d flower which is HERE.

First of all you will need:

2 large flowers die cut from the Fun Flower Die, 1 medium flower from the same die and a large flower from the Boho Blossoms punch, other products needed are glue, snips, dimensionals and rhinestones to finish, all products used are SU! and available through your demonstrator, if you don't have a demo message me for more details :-)

So to begin ink the edges of all your flowers. Use the bone folder to curve the first two flowers gently down and the second two flowers upwards,

working left to right, take the first flower and fold gently into four, without creasing, and snip the bottom off

take the next flower and snip a line into the centre

run a line of glue down the edge of the cut 

fold over and adhere to give it some depth

add a line of glue around the hole you made in the first flower and adhere the second one on top

add TWO dimensionals to the centre of the flower and adhere the medium size die cut flower to these

then glue the centre of this flower to add the punched flower layer

 finish with rhinestones or perhaps a button would look nice

to adhere this flower to your card add two dimensionals at three points around the base

and there you have it, this is the card I used it on, there are more details HERE 

and I also used it on THIS card, THIS card and THIS card,

Well, I hope you have enjoyed this tutorial and I hope you give it a go, I am looking forward to seeing your version :-)

Stampin' Hugs for today,